tool retaining screws and not by the tool itself. This causes an erosion and the subsequent rupture of the tip. The breaking in these cases usually appears at the top of the hammer pin as a result of the idle strokes when the tip 63s H CAT of the tool is separated from the
LOW TEMPERATURES At low temperatures it is recommended that the tools be heated before use and if it is possible use at low speed for a progressive increase in H 63s CAT temperature of the machinery.
DO NOT BEND Using the power of the arm of the hammer to break, or using the tool of the hammer as a lever sooner or later it will break. The same thing occurs when the tool leans incorrectly or when it is H CAT 63s introduced continuously between cracks.
