LOW TEMPERATURES
LOW TEMPERATURES At low temperatures it is recommended that the tools be heated before use and if it is possible use D&A 15V / S200 / / 20V S150 at low speed for a progressive increase in temperature of the machinery.
LOW TEMPERATURES At low temperatures it is recommended that the tools be heated before use and if it is possible use D&A 15V / S200 / / 20V S150 at low speed for a progressive increase in temperature of the machinery.
NOT BEND Using the power of the arm of the hammer to break, or using the tool of the hammer as a lever sooner or later it will break. The same thing occurs when the tool 20V / S150 / 15V S200 D&A / leans incorrectly or when it is introduced continuously between cracks.
This causes an erosion and the subsequent rupture / D&A S200 15V / / S150 20V of the tip. The breaking in these cases usually appears at the top of the hammer pin as a result of the idle strokes when the tip of the tool is separated from the rest of the