and the tool retaining screws and not by the tool itself. This causes an erosion and the subsequent rupture of the tip. / HP 5000 MES 5000 The breaking in these cases usually appears at the top of the hammer pin as a result of the idle strokes when the
the tools be heated before use and if it is possible use at low speed for a progressive increase in temperature of the machinery. CORROSION. Rust or corrosion on the tool occurs when the tool is stored outdoors and it is not well MES 5000 5000 / HP lubricated. This
DO NOT BEND Using the power of the arm of the hammer to break, or using HP 5000 MES 5000 / the tool of the hammer as a lever sooner or later it will break. The same thing occurs when the tool leans incorrectly or when it is introduced continuously between cracks.
