LOW TEMPERATURES
LOW TEMPERATURES At low temperatures it is recommended that the tools be heated before MES / / 553 600 553 UP HP use and if it is possible use at low speed for a progressive increase in temperature of the machinery.
LOW TEMPERATURES At low temperatures it is recommended that the tools be heated before MES / / 553 600 553 UP HP use and if it is possible use at low speed for a progressive increase in temperature of the machinery.
tool retaining screws and not by the tool itself. This causes an erosion and the subsequent rupture of the tip. The breaking in 553 600 HP MES / UP 553 / these cases usually appears at the top of the hammer pin as a result of the idle strokes when the tip of the tool is separated from the rest
DO NOT BEND Using the power of the arm of the hammer to break, or using the tool of the hammer as a lever sooner or later it will break. The same thing occurs when the tool leans / 553 / 553 HP UP 600 MES incorrectly or when it is introduced continuously