not by the tool itself. This causes an erosion and the subsequent rupture of the tip. The breaking in these cases usually appears at the top of the hammer pin as a result of the idle strokes when the tip of the tool is separated from MES 1750 HP / 1800 1800 MES / the rest of the
LOW TEMPERATURES At low temperatures it is recommended that the tools be heated before use and if it is possible use at low speed HP 1750 / / 1800 MES MES 1800 for a progressive increase in temperature of the machinery.
DO NOT BEND Using the power of the arm HP 1800 1750 / MES MES 1800 / of the hammer to break, or using the tool of the hammer as a lever sooner or later it will break. The same thing occurs when the tool leans incorrectly or when it is introduced continuously between cracks.
