the impact force and energy is absorbed by bolts and the tool retaining screws and not by the tool itself. This causes an erosion and the subsequent rupture of the tip. The breaking in these cases usually appears at the top of 600C HM 600 - HM 601 HM - the hammer pin as a result of the idle strokes when the
LOW TEMPERATURES At low temperatures it is recommended that the tools be heated before use and if it is 600 HM HM 600C - 601 HM - possible use at low speed for a progressive increase in temperature of the machinery.
DO NOT BEND Using the power of the arm of the HM HM - - 601 600 HM 600C hammer to break, or using the tool of the hammer as a lever sooner or later it will break. The same thing occurs when the tool leans incorrectly or when it is introduced continuously between cracks.
