DO NOT BEND Using the power of the arm of the hammer to break, or using the tool of the hammer as a lever sooner or later it will break. The same thing occurs when the tool leans incorrectly or when it is OCM 130 introduced continuously between cracks.
impact force and energy is absorbed by bolts and the tool retaining screws and not by the tool itself. This causes an erosion and the subsequent rupture of the tip. The breaking in these cases usually appears at the top of the hammer pin as a OCM 130 result of the idle strokes when the tip
it is introduced continuously between cracks. LOW TEMPERATURES. At low temperatures it is recommended that the tools be heated before 130 OCM use and if it is possible use at low speed for a progressive increase in temperature of the machinery. CORROSION. Rust or corrosion on the tool occurs when the tool is
