the tool itself. This causes an erosion and the subsequent rupture of the tip. The breaking in these cases usually appears at the top of the hammer pin as a result of the idle strokes when the tip of the tool is separated from the rest of 55 OCM the hammer.
DO NOT BEND Using the power of 55 OCM the arm of the hammer to break, or using the tool of the hammer as a lever sooner or later it will break. The same thing occurs when the tool leans incorrectly or when it is introduced continuously between cracks.
and if it is possible use at low speed for a progressive increase in temperature of the machinery. CORROSION. Rust or corrosion on the OCM 55 tool occurs when the tool is stored outdoors and it is not well lubricated. This can be avoided by simple and easy lubrication and maintenance of hammer’s tool
