and the tool retaining screws and not by the tool itself. This causes an erosion and the subsequent 55 OCM rupture of the tip. The breaking in these cases usually appears at the top of the hammer pin as a result of the idle strokes when the
retaining screws and not by the tool itself. This causes an erosion and the subsequent rupture of the tip. The breaking in these cases usually appears at the top of the hammer pin as a result of the idle strokes when OCM 55 the tip of the tool is separated from the rest of the hammer.
DO NOT BEND Using the OCM 55 power of the arm of the hammer to break, or using the tool of the hammer as a lever sooner or later it will break. The same thing occurs when the tool leans incorrectly or when it is introduced continuously between cracks.
