DO NOT BEND Using the power of the arm of the hammer to break, or using the tool of the hammer as a lever sooner or later it will break. The same thing occurs when the tool leans incorrectly or when it is introduced continuously 270 S / / 270 275 between cracks.
the tool retaining screws and not by the tool itself. This causes an erosion and the subsequent rupture of the tip. The breaking in these cases usually appears at the top of the hammer pin as a result of the idle strokes when the / 270 275 / S 270 tip of the tool is
LOW TEMPERATURES At low temperatures it is recommended that the tools be heated before use and if it is possible use at low speed for a progressive increase in temperature 270 275 S / 270 / of the machinery.