and energy is absorbed by bolts and O&K H45 the tool retaining screws and not by the tool itself. This causes an erosion and the subsequent rupture of the tip. The breaking in these cases usually appears at the top of the hammer pin as a result of the idle strokes when the tip
NOT BEND Using the power of the arm of the hammer to break, or using H45 O&K the tool of the hammer as a lever sooner or later it will break. The same thing occurs when the tool leans incorrectly or when it is introduced continuously between
it is recommended that the tools be heated before use and if it is possible use at low speed for a progressive increase in temperature of the machinery. CORROSION. Rust or corrosion on the tool H45 O&K occurs when the tool is stored outdoors and it is not well lubricated. This can be avoided