possible use at low speed DMS 50 for a progressive increase in temperature of the machinery. CORROSION. Rust or corrosion on the tool occurs when the tool is stored outdoors and it is not well lubricated. This can be avoided by simple and easy lubrication and maintenance of hammer’s tool away from moisture when
the tool retaining screws and not by the tool itself. This causes an erosion and the subsequent rupture of the tip. The 50 DMS breaking in these cases usually appears at the top of the hammer pin as a result of the idle strokes when the tip of the tool
CORROSION Rust or corrosion on the tool occurs when the tool is stored outdoors and it is not well lubricated. This can be avoided by simple and easy lubrication and maintenance of DMS 50 hammer’s tool away from moisture when not in use.
