DO NOT BEND Using the power of the arm of the hammer to break, or SCM MDO 5 500 TS 500 / - using the tool of the hammer as a lever sooner or later it will break. The same thing occurs when the tool leans incorrectly or when it is introduced continuously between cracks.
screws 500 TS MDO 5 / - SCM 500 and not by the tool itself. This causes an erosion and the subsequent rupture of the tip. The breaking in these cases usually appears at the top of the hammer pin as a result of the idle strokes when the tip of the tool
LOW TEMPERATURES At low temperatures it is recommended that the tools be heated before use and if it is possible use at low speed for a progressive increase 500 500 5 MDO - / TS SCM in temperature of the machinery.
