screws and not by the tool itself. This causes an erosion and the subsequent rupture of the tip. The breaking in these cases usually appears at the top of the hammer pin as a result of the idle strokes when the tip of the tool is separated 200 HF 45 - GOA GOA 205 40 - / from the rest of the hammer.
DO NOT BEND Using the power of the arm of the hammer to break, or using the tool of the hammer as a lever sooner or later it will break. The same thing occurs when the tool leans incorrectly or when it is introduced continuously between 200 GOA 40 45 GOA / - - 205 HF cracks.
it is introduced continuously between cracks. LOW TEMPERATURES. At low temperatures it is recommended that the tools be heated before use and if it is possible use at low 40 HF - 45 205 / GOA GOA - 200 speed for a progressive increase in temperature of the machinery. CORROSION. Rust or corrosion on the tool occurs when the tool is
