the tool to avoid the friction between metals. DO NOT BEND. Using the power of the arm of the hammer to break, YC 300 or using the tool of the hammer as a lever sooner or later it will break. The same thing occurs when the tool leans incorrectly or when it is
DO NOT BEND Using the power 300 YC of the arm of the hammer to break, or using the tool of the hammer as a lever sooner or later it will break. The same thing occurs when the tool leans incorrectly or when it is introduced continuously between cracks.
is absorbed by bolts and the tool retaining screws and not by the tool itself. This causes an erosion and the subsequent rupture of the tip. The breaking 300 YC in these cases usually appears at the top of the hammer pin as a result of the idle strokes when the