LOW TEMPERATURES At low temperatures it is recommended that the / SBC 80 SB 300 30 650 Copco, - HS Atlas KRP 610 tools be heated before use and if it is possible use at low speed for a progressive increase in temperature of the machinery.
screws and 300 Copco, Atlas 650 SBC 610 80 30 KRP - SB / HS not by the tool itself. This causes an erosion and the subsequent rupture of the tip. The breaking in these cases usually appears at the top of the hammer pin as a result of the idle strokes when the tip of the tool is separated from
CORROSION Rust or corrosion on the tool occurs when the - / 650 300 Atlas KRP SB Copco, HS 80 610 30 SBC tool is stored outdoors and it is not well lubricated. This can be avoided by simple and easy lubrication and maintenance of hammer’s tool away from moisture when not in use.