the tool retaining screws and not by the tool itself. This causes an erosion and the subsequent rupture of the tip. The breaking in these cases usually appears at the top of the hammer pin as a result of the 610 HS 650 80 300 - Atlas 30 KRP / Copco, SB SBC idle strokes when the tip of the tool is separated from the rest of the
LOW TEMPERATURES At low temperatures it is recommended - 80 Copco, 610 / Atlas HS 300 SB 30 SBC KRP 650 that the tools be heated before use and if it is possible use at low speed for a progressive increase in temperature of the machinery.
the piston does not stroke the hammer tool, and the impact force and energy is absorbed by bolts and the tool SBC 30 650 610 80 Copco, - HS 300 SB / KRP Atlas retaining screws and not by the tool itself. This causes an erosion and the subsequent rupture of the tip. The breaking in these cases usually appears at
