DO NOT BEND Using the power of the arm of the hammer to break, or using / 110H SB Copco, 15 Atlas 152 - TEX 150 HS KRP 255 150 / MK2 SBC 50 - the tool of the hammer as a lever sooner or later it will break. The same thing occurs when the tool leans incorrectly or when it is introduced continuously
LOW TEMPERATURES At low temperatures it is recommended that the tools be heated before use and if it is possible use at low speed for a progressive increase in temperature of the machinery.
not by the tool itself. This causes an erosion and the subsequent rupture of the tip. The breaking in these cases usually appears at the top of the hammer pin as a result of the idle strokes when the tip of the tool is separated from the rest of 110H MK2 TEX SB - 150 SBC - Copco, Atlas / HS 15 150 152 / 255 50 KRP the hammer.